New in the library Presented by Jaadu Digital ↗
Free Business Profile Free tools

Free engineering tool · verified formulas

Sheet Metal Bend Calculator

No sign-up · calculates in your browser

Bend allowance, bend deduction, outside setback and developed flat-blank length from thickness, inside radius, angle and K-factor.

Free engineering tool
Formula, worked example and FAQs below · results update as you type

°

K

Air bending: ≈0.33 (R<T), 0.40–0.45 (R≈T), 0.50 (R>3T)



Results

Flat blank length
—

Bend allowance
—

Bend deduction
—

Outside setback
—

Results are engineering estimates for preliminary design. Verify critical values with codes, vendor data or a qualified engineer.

Advertisement
Embed this free tool on your website or blog

Free to embed on engineering blogs, university guides, and plant wikis (zero login required).

Formula used

Bend allowance BA = (π ÷ 180) × A × (R + K × T)

Outside setback OSSB = tan(A ÷ 2) × (R + T)

Bend deduction BD = 2 × OSSB − BA

Flat length = L1 + L2 − BD (flanges measured to the outside mould line).

How to use this calculator

  1. Measure flanges to the outside of the bend (outside mould line).
  2. Enter the angle the sheet is bent through — 90° for an L-bracket.
  3. Use your press-brake shop’s proven K-factor where available.
  4. Cut a test piece and refine K for production.

Worked example

2 mm sheet, 2 mm inside radius, 90° bend, K = 0.44, flanges 50 mm and 30 mm: BA = 1.5708 × (2 + 0.88) = 4.524 mm; OSSB = tan 45° × 4 = 4.000 mm; BD = 8 − 4.524 = 3.476 mm; flat length = 80 − 3.476 = 76.52 mm.

Frequently asked questions

What is the K-factor?

The ratio of the neutral-axis position to thickness. The neutral axis moves toward the inside of the bend, so K is usually 0.3–0.5.

Bend allowance or bend deduction — which do I use?

Use BD when your drawing dimensions are to outside mould lines (most common). Use BA when you add the arc length to the flat inside lengths.

Why does my part come out long?

Usually the K-factor or inside radius is wrong. In air bending, the inside radius is set by the V-die width (≈ 15–17 % of V for mild steel), not the punch tip.

Your saved guides

Saved only in this browser. No account required.

Advertisement