Maximum deflection, bending moment and stress for simply supported, cantilever and fixed beams with common steel sections.
Results
- Maximum deflection
- Span ÷ deflection
L/δ- Maximum bending moment
- Maximum bending stress
- Stress ÷ strength
%- Section Ixx used
cm⁴
Results are engineering estimates for preliminary design. Verify critical values with codes, vendor data or a qualified engineer.
Formula used
| Case | δmax | Mmax |
|---|---|---|
| Simply supported, centre load P | PL³ ÷ 48EI | PL ÷ 4 |
| Simply supported, uniform w | 5wL⁴ ÷ 384EI | wL² ÷ 8 |
| Cantilever, end load P | PL³ ÷ 3EI | PL |
| Cantilever, uniform w | wL⁴ ÷ 8EI | wL² ÷ 2 |
| Fixed–fixed, uniform w | wL⁴ ÷ 384EI | wL² ÷ 12 |
Bending stress σ = M × c ÷ I, where c is the distance from the neutral axis to the outer fibre.
How to use this calculator
- Choose the support and load case closest to your beam.
- Enter span and load; include self-weight in the uniform load for long spans.
- Pick a section type and dimensions, or type Ixx from a steel table for rolled sections.
- Compare deflection with your limit and stress with the material’s allowable value.
Worked example
A 100 × 200 mm solid steel section spans 3 m with a 10 kN centre load. I = 0.1 × 0.2³ ÷ 12 = 6.67 × 10⁻⁵ m⁴. δ = 10 000 × 3³ ÷ (48 × 200 × 10⁹ × 6.67 × 10⁻⁵) = 0.42 mm (L/7100). M = 10 × 3 ÷ 4 = 7.5 kN·m and σ = 7500 × 0.1 ÷ 6.67 × 10⁻⁵ = 11.3 MPa.
Frequently asked questions
Does this include the beam’s own weight?
Only if you add it. Steel self-weight in kN/m is roughly mass per metre (kg/m) × 0.0098.
Is the stress check a full design check?
No. It ignores lateral-torsional buckling, shear, web crippling and safety factors. Use IS 800, Eurocode 3 or AISC for design and get it checked by a qualified engineer.
Which deflection limit should I use?
L/360 for floors carrying brittle finishes, L/250 for general beams and L/180 for many cantilevers and roof members — check your project specification.