Calculate Stairmand high-efficiency cyclone inlet velocity, Lapple 50 % cut-point particle diameter (d50 in µm) and estimated gas pressure drop.
Results
- Inlet velocity
- Cut-point diameter (d50)
- Estimated pressure drop
Results are engineering estimates for preliminary design. Verify critical values with codes, vendor data or a qualified engineer.
Formula used
Stairmand high-efficiency proportions: inlet area a × b = (0.5 Dc) × (0.2 Dc) = 0.1 Dc², effective turns Ne = 5.
Lapple cut-size: d50 = √(9·μ·b ÷ (2·π·Ne·vin·(ρp − ρg))). Pressure drop ΔP ≈ 6.4 × ½·ρg·vin².
How to use this calculator
- Enter actual gas volumetric flow at operating temperature and pressure.
- Enter cyclone cylinder body diameter Dc.
- Enter gas viscosity, gas density and particle density.
- Aim for 15–22 m/s inlet velocity; follow with a <a href="/bag-filter-sizing-calculator/">Bag Filter</a> for sub-5 µm emissions compliance.
Worked example
At 5,000 Am³/h in an 800 mm Stairmand cyclone (2500 kg/m³ dust, air at 20 °C), inlet velocity is 21.7 m/s, cut-size d50 ≈ 4.3 µm and pressure loss ≈ 1,808 Pa (184 mmH2O).
Frequently asked questions
What does a cyclone d50 cut-size of 5 µm mean?
Particles of 5 µm aerodynamic size have a 50 % chance of being collected; larger particles are captured at progressively higher efficiency (80–99 %), while finer sub-micron dust passes out the vortex finder.
Why do multi-cyclone banks perform better than one giant cyclone?
Splitting flow across smaller-diameter cyclones increases centrifugal acceleration (v²/r) at the same inlet velocity, lowering d50.
What happens if cyclone inlet velocity is too high (> 26 m/s)?
Pressure drop climbs with v², abrasive wear accelerates rapidly on the volute and cone, and particle re-entrainment from the wall can reduce collection efficiency.