Convert motor power and speed to shaft torque, or torque to power, and estimate full-load current for three-phase and single-phase motors.
Results
- Shaft torque
- Shaft power
- Electrical input
kW- Full-load current (est.)
A
Results are engineering estimates for preliminary design. Verify critical values with codes, vendor data or a qualified engineer.
Formula used
T [N·m] = 9549.3 × P [kW] ÷ n [rpm] · P = T × n ÷ 9549.3
Three-phase current: I = Pin × 1000 ÷ (√3 × V × cos φ), where Pin = P ÷ η. Single-phase: I = Pin × 1000 ÷ (V × cos φ).
The constant 9549.3 is 60 000 ÷ 2π: it converts rpm to rad/s and W to kW.
How to use this calculator
- Choose whether you know the power or the torque.
- Enter shaft speed from the nameplate (synchronous speed minus slip).
- Add voltage, power factor and efficiency to estimate current for cable and protection sizing.
- Switch units on any field — results update instantly.
Worked example
A 7.5 kW, 4-pole motor runs at 1450 rpm. Torque = 9549.3 × 7.5 ÷ 1450 = 49.4 N·m. At 90 % efficiency the motor draws 8.33 kW; on a 415 V supply at power factor 0.85 the current is 8333 ÷ (1.732 × 415 × 0.85) = 13.6 A. Nameplate current will differ slightly because efficiency and power factor vary by make.
Centrifugal Blower
Direct-driven backward-curved centrifugal fan: watch air enter the eye, get flung outward by the impeller and leave tangentially through the volute.
Drag to rotate · scroll or pinch to zoom · tap a part to learn what it does
Frequently asked questions
Why is torque higher at lower speed for the same power?
Power is torque multiplied by angular speed. A 4-pole (1450 rpm) motor of the same kW produces about twice the torque of a 2-pole (2900 rpm) motor, which is why gearboxes trade speed for torque.
Can I use this current for MCCB or cable sizing?
Use it as a check only. Size protection from the motor nameplate full-load current and the applicable code (IEC 60364, IS 732 or NEC), including starting current and derating.
What is the difference between kW and hp?
1 metric hp = 0.7355 kW; 1 mechanical (imperial) hp = 0.7457 kW. This calculator uses the mechanical horsepower used on IEC/NEMA motor plates.